Welded Wire FenceHeavy gauge welded wire fence panels are the preferred solution for perimeter protection of sensitive sites. Cutting an opening in the wire mesh fence panels is time-consuming and difficult, and the small openings discourage climbing by eliminating hand and foot holds. Galvanized wire panels will not unravel or lose structural integrity if cut. The panels may be electrified, and/or buried to discourage access from below.

The wire fencing panels are installed on Gregory C-Post fencing framework for added strength. Using heavy duty fittings with our high security fence can significantly increase physical security and deter access to areas that may have been vulnerable in the past.

The Welded Wire Fence Systems provides clean, distortion-free visibility. Sophisticated passive or active alarm systems integrate well with our systems due to their low noise factor and limited wind-base movement minimizing false alarms.

 

Welded Wire Panel Sizes

Welded Wire Panels are available in 1/2" x 3" openings. The panels are 87" wide for 7' on center line post installations. They come in 8', 9', 10' or 12' heights. Eight-foot panels can be vertically stacked to make a 16' height. Three horizontal rails are recommended for all heights.

Benefits of Welded Wire Panels

Anti-Cut and Anti-Climb

Heavy-gauge wire and small welded joints make cutting or establishing finger holds virtually impossible.

Increased Visibility

The flat, two-dimensional profile makes it easy to see through the wire mesh fence panels. 

Corrosion Resistant

The welded wire panels are stubborn against breakdown caused by aging and weather. We offer the panels in a galvanized or PVC coating.

Economical

Welded wire fence panels are typically less expensive than similar security fence solutions.

Complete the Welded Fence Systems with Super-C Framework

Gregory Fence's Super-C framework, as specified by ASTM F1043, provides greater strength than Sch. 40 pipe. It is coated with a minimum of 2 oz. of zinc per square foot (the heaviest coating on the market). This provides greater corrosion protection than any tubular pipe. All at a lower cost!

Gregory Fence C-Post

Gregory Fence C-Post

Widely Specified for Greater Strength and Corrosion Protection

The Gregory C channel fence post is stronger, quicker to install and more resistant to corrosion over time. This fence framework depends on the more effective C-shape metal fence posts that offer greater bending strength perpendicular to the fence line. The C-Post fence benefits include:

  • Can be mechanically driven without the use of concrete
  • Heaviest amount of continuously coated zinc available on any framework on the market
  • Open-channel design eliminates condensation buildup inside, reducing maintenance
  • Drives quicker, easier and self-anchors more effectively than tubular posts

These metal posts for fence are available in any length.

Learn about the C-Post

Made in the USA

Our perimeter protection solutions will meet your most demanding security challenges. At Gregory Fence, we manufacture our fence products—from standalone fence posts to complete fence systems—using domestic steel and meet all Buy America requirements.

Made in USA
American Fence Association
ASTM
Chain Link Manufacturers Institute
CFIA-ACIC

Partner with Gregory Fence

No matter your fence requirements, we have the capabilities to meet your needs. With fence posts, brackets and fittings stocked across the country, we’re available with quick fencing solutions whenever project needs arise. Contact us today to get started on your next perimeter protection project.